Схема ten-tec omni 7

схема ten-tec omni 7
After you have installed the jumpers, be sure to set the sound card audio levels as outlined in the SignaLink manual. If you do not set the levels correctly, then the SignaLink may not transmit, and you might mistake the problem for incorrect jumper settings. Connect the supplied right-angle mono audio cable between the SignaLinks SPKR jack, and the KX2/KX3s Phones jack. Be sure that both plugs are fully inserted. KX2/KX3 Radio Settings: 1 — The Mic Bias setting in the KX2/KX3s menu system should be turned OFF if you are using jumper wires. All in all I love this radio. If my 6 meters tunes up, I may jump in for a second one. I really would like a panadapter thought. The SignaLink USB is always powered by the computer and never needs external power. For HF operation on the FT-847, we recommend that you attach the SignaLink to the «Data I/O» jack.


After setting the audio variables I continue to get regular unsolicited Great Audio! reports. I have found lots of help on the various Ten Tec forums and even through Ten Tec, although they have been going through some changes as ownership shifted the last couple of years. Your radio will NOT be damaged if you install the PTT jumper using the wrong configuration — you just wont be able to transmit! The Omni VII and the Flex 3000 are both keepers, I still own both. KT8DX Rating: 5/5 Jul 17, 2015 09:30 Send this review to a friend Easy flexibility&nbsp Time owned: 6 to 12 months Ok — first off — I am NOT in love with this radio. You can use these values, or those shown in the FT-847 manual. Note that there is a limit to the number of files you can download.

Manuals, Diagrams and Brochures None available View more manuals and documents Can you supply additional photos or documents? The way you can easily dig down into the dirt for very weak signals. Note that the K3 also has a menu setting for the «Line Out» level, which can be turned up if needed to increase the RX Audio going into the SignaLink. The way you can quiet the receiver down by using the RF Gain, Attenuator, and NR functions and still receive the signal.

Похожие записи:

Comments are closed, but trackbacks and pingbacks are open.